Instructions: Calimera Pendant Light - V2

Installation

Be sure to switch off the circuit breaker and ensure that the cable is not live.

Set the desired hanging height of the light before attaching it. To do this, press in the small pin on the ceiling mount and pull the cable, or push the cable into the mount.

Although the hanging height can also be adjusted after the light has been mounted, it is easier to set the height roughly beforehand while the light is not yet attached.

If you are sure that you will not want to adjust the height later, we recommend closing the two cable locks in the ceiling mount, which provide additional support for the cables.

Attach the rail to the desired position on your ceiling. The two pre-installed screws point downward and will be guided through the pre-drilled holes in the ceiling mount in the next step.

Now connect the cables to the ceiling connections. Then attach the ceiling mount to the ceiling by guiding the two downward-facing screws through the pre-drilled holes in the ceiling mount. To secure the ceiling mount, screw the two protective caps onto the protruding ends of the two screws. The light is now suspended.

You can then fine-tune the hanging height of the light again if you wish.

-> If present, be sure to tighten the small screws on the lamp body again with a screwdriver; these secure the suspension cables.

Remote control

Your light is automatically connected to the included remote control. However, if your light does not respond to the remote control's signals, you can reconnect it by following these steps:

1) Press and hold the on and off buttons simultaneously for 6 seconds. The red LED flashing confirms that the remote control has been reset.

2) Make sure that your light is switched off using the light switch. Now switch the light back on using the light switch.

3) Press and hold the power button on the remote control for 6 seconds. The light will briefly illuminate when the connection has been established successfully.